To reset, first find the reset pinhole at the back of the modem between the Power and Ethernet ports.Ģ. Depending on the state of the modem, sometimes a hard reset will restore services.ġ. That clears all settings like personalized wireless names, passwords, and port forwarding, etc. The Internal Port End field will change automatically.Ī factory reset will take the modem back to factory settings. Specify the External Port Start, External Port End, and Internal Port Start. In the Protocol box you can specify UDP, TCP, or both.Ĩ. In the Server IP Address specify the IP address of your device you are forwarding to.ħ. Click Custom Service and type the name you want to use like "dervex camera"Ħ. Next, while still under Advanced Setup, click NAT.ĥ. Uncheck the Enable or disable UPnP protocol box, then click Apply/Save button.ģ. Click Advanced Setup on the left to branch it out and then click UPnP.Ģ. To see what is currently connected to your 1704N modem, click on Device Info, and then ARP to view connected devices and their IP addresses.ġ. With port forwarding, it is important that you know the IP address of your device you are forwarding ports to. In computer networking, port forwarding redirects a communication request from one address and port number combination to another. Check it again and click Apply/Save to toggle wireless back on. Anything connected wirelessly will lose connection at this point. From the Interface click Wireless on the left side, then uncheck Enable Wireless, and click Apply/Save. The WPA Pre-Shared Key is where you can specify the new password.ġ. The Network Authentication dropdown lets you specify the security type.ģ. From the Interface click Wireless on the left side, then click Security.Ģ. From the Interface click Wireless on the left side, then replace whatever is in the SSID with your preferred network name.Ĭhange the wireless password or security type.ġ. If replacing a modem, never use the prior modem's cord.įind all modem configurations here including wireless settings and port forwarding.Ĭhange your wireless network’s name. Power: Power cord, only use provided power cord with this modem. Green blinking: Wireless traffic going out or coming in. The username and password combination in the modem is not correct. Possibly needs configured or is in bridge mode. Blinking green: Traffic going out or coming in. Off: No connection seen between modem and Windstream. Blinking green: Establishing connection between modem and Windstream. The link between modem and Windstream is established. Try another outlet, power cycle, and hard reset modem. Check connecting cables, and try another outlet. Your DSL modem has several lights which can be used to see current statuses, and diagnose installation and connection problems. 16 Wireless clients allowed by default (can be changed).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |